1. Is there any difference between welding positioner and welding machine in welding positioner?

Welding positioner and welding in positioner are obviously different, so the answer to this question is yes, and there is no doubt. Because, in the welding positioner, there is a reducer, mainly for the reducer, while in the welding machine, there is no reducer.

2. What are the main considerations for the selection of different positioners?

For the selection of different positioners, they should consider the specific use requirements and their specific uses, rather than the first consideration of their brands. Because it is necessary to determine what kind of positioner to use first, whether it is a small-scale positioner, a large-scale positioner or a special positioner. When this is determined, other aspects such as the brand of the positioner can be considered.

3. In the welding positioner, what is the cause of converter overcurrent alarm?

In the positioner, if its frequency converter over-current alarms, then there are specific reasons. The specific reasons are: first, in the motor, its connection distance is too long, or the use of inappropriate connecting wire, etc.; second, in the use process of the positioner, its power consumption is too large, or the power supply line configuration is unreasonable, the knowledge of its total voltage is too low; third, it is The frequency converter itself has quality problems.

The above questions, as well as the specific answers given, are all about the positioner and welding positioner. At the same time, they are also the basic knowledge and content of the positioner. Therefore, we must firmly grasp them in time, so that we can achieve what we have learned and realize the flexible use of knowledge, so as to avoid wasting such a good learning opportunity.